• Output voltagepeak   4 ohm mode > 150 V, 2 ohm mode > 118 V
    Output current cut-out limitpeak (with 5 retries)   4 ohm mode > 55 A, 2 ohm mode > 80 A
    Output powers and permissible nominal loads   Output C1 Output C2 Output C3 Output C4
    8 ohm (4 ohm mode)
      1,400 W 1,400 W 1,400 W 1,400 W
    4 ohm (4 ohm mode)
      2,800 W 2,800 W 2,800 W 2,800 W
    2.7 ohm (2 ohm mode)
      > 2,500 W1) > 2,500 W1) > 2,500 W1) > 2,500 W1)
    2.0 ohm (2 ohm mode)   > 3,400 W1) > 3,400 W1) > 3,400 W1) > 3,400 W1)
    1.6 ohm (only for information – 2 ohm minus 20 %)   > 4,200 W1) > 4,200 W1) > 4,200 W1) > 4,200 W1)

    1) Each channel provides individually considered extremely high, load stableperformance at nominal impedances down to 2 ohms. The total power of all four channels is at practical burst signals typically 20 kW (40 kW for a short time). Will be permanently accessed more power than the power supply (mains and supply) can provide, so the hardware limiter will reduce the output levels. The hardware limiter should not be used as a signal compressor. It is up to the user to properly deal with the available power pool. 

 

Number of individual inputs   4
Number of individual outputs   4
THD at 1 kHz at 4 ohms and -3 dB   < 0.03 %
Frequency response 20 Hz to 20 kHz at 8 ohms at -15 dB   + / – 0.5 dB (typically + / – 0.05 dB)
Damping factor at 8 ohms, 100 Hz   > 1000, typically 1500 comprising the SpeakON® connectors, typ. 5 mOhms
Latency without DSP or bypass (connector to connector)   0.000 ms, ZeroLatency™ technology
Signal limiter   Yes
Current monitoring   Yes
LF limiter   Yes, reduces the gain gently
HF limiter   Yes, reduces the gain gently
AC mains supply monitoring /
Power management
  Yes
Rearmounted gain factor toggle switch   26 dB and 32 dB basic gain
Frontmounted rotary gain controls   0 dB to – 100 dB, digitally controlled
Rearmounted bridge mode switch   Channel 1 and 2: Yes / Channel 3 and 4: Yes
AC mains supply input   1 x Neutrik® PowerCON®
Analogue input and slave connectors   4 x 3-pin Neutrik® full metal socket and 4 x 3-pin Neutrik® full metal plug
Amplifier output connectors   4 x 4-pin high current Neutrik® SpeakON®
Resolution ADC input   24 bit
Sampling frequency ADC input   96 kHz default, optionally 48 kHz and 192 kHz (selectable via DSPSoftEngine™)
Latency with active DSP (connector to connector)   0.2 ms at 96 kHz sampling frequency, QuasiAnalog™ technology
DSP delay
  0 ms to 340 ms (115 m) in total per channel pair at 96 kHz
DSP memory locations
  300
DSP RMS limiter   Yes, TrueRMS, optionally with ForecastLimiter™ by DSPSoftEngine™
DSP Peak limiter   Yes, optionally with ForecastLimiter™ by DSPSoftEngine™
Hoellstern® DSPSoftEngine™   Yes, comprehensive basic setups, expandable as desired
Remote control network   Yes, D-Sub 9 socket, RS-485 network, RS-232 point-to-point, Hoellstern® protocol
Frontside status LEDs display   Standby, Signal Input, VU -6 dB, VU -3 dB , VU 0 dB and Signal Limit
Frontside error LEDs display   Current, HF / LF Limiter, Temperature
Frontside rotary controls   One rotary step control with digital sensing per channel
Frontside switches   Standby / ON switch, software-controlled
AC mains input   180 VAC to 265 VAC, operative from 70 VAC, 400 V tolerant
Starting current   10 A softstart
Intelligent AC mains power management   Yes, iCVP® technology, dual hard-regulated switching power supply
Efficiency   Up to 84 % (AC mains input to audio output)
AC mains fusing   16 A (class B breaker), for personal alarm systems class C circuit breaker or better
Housing construction   Black powder-coated steel body , anodised aluminium front panel
Handles and 19″ rack ears   Yes, anodised aluminium, replaceable
Air filter and grids   Open-pore foam, spring steel grids, black powder-coated, vacuum-cleanable
Air rate and fans   3 fans, temperature-controlled speed, front sucking
Dimensions   Width: 19″ (483 mm), height: 2 RU (88 mm), overall depth: 290 mm from rack ears
Weight   12 kg (26 lbs), shipping weight 14 kg (30 lbs)

Auvilight / ARC ?

Knowhow - Ons bedrijf Auvilight, voortgekomen uit Roosen Showequipment en Roosen Showshop, is al meer dan 35 jaar actief in nederland. Hier door hebben wij uitgebreide kennis vergaard over audio, video en lighting.

 
 

Service - Audiovisuele projecten worden door ons ontworpen en ondersteund, door en met een team van ervaren specialisten, allen met passie voor beeld, licht en geluidstechniek. Deze passie brengen wij graag over op onze klanten.

Kwaliteit - Dankzij onze importeurschappen als Sommer Cable, Hoellstern, Pro Audio Technology en LAWO kunnen wij u een uitgelezen pakket aan audiovisuele producten en oplossingen bieden, samengesteld met oog voor kwaliteit en flexibiliteit.

 

Vraag een offerte aan

Ongeldige invoer

Ongeldige invoer

Ongeldige invoer

Ongeldige invoer

Ongeldige invoer






Auvilight
Europaweg 93
5707 CL Helmond

0492 - 477 722
info@auvilight.nl